Safety Measures - Vitek VT-4208 CL Betriebsanweisung

MULTICOOKER
The main purpose of the multicooker is quick and
quality food cooking.
Description
1. Multicooker body
2. Lid opening button
3. Cooking bowl
4. Heating element
5. Temperature sensor
6. Lid blocking system valve
7. Pressure control valve
8. Protection screen clamp
9. Protection screen
10. Multicooker lid
11. Carrying handle
12. Power cord connector
13. Drip tray
14. Control panel
15. Display
16. Lid blocking handle
17. Steam valve
18. Steam cooking basket
19. Measuring cup
20. Soup ladle
21. Spatula
22. Power cord
23. Yogurt cups
Control panel
24. «Delayed start» button
25. «Time» button
26. «Multicook» button
27. «—» button
28. «Start» button
29. «Menu» button
30. «+» button
31. «Stop/Reheat» button
32. «Pressure/Steam Release» button
ATTENTION!
For additional protection it is reasonable to install a
residual current device (RCD) with nominal operation
current not exceeding 30 mA. To install RCD contact a
specialist.

SAFETY MEASURES

Before using the unit, read this instruction manual
carefully and keep it for future reference.
Use the unit for intended purposes only, as specified
in this manual. Mishandling the unit can lead to its
breakage and cause harm to the user or damage to his/
her property.
•
Before using the unit, examine the power cord and
the power cord connector located on the unit body
closely and make sure that they are not damaged.
VT-4208.indd 3
Never use the unit if the power cord or power cord
jack is damaged.
•
Before switching the unit on make sure that voltage
of the mains corresponds to unit operating voltage.
•
Power cord is equipped with "euro plug"; plug it into
the socket with reliable grounding contact.
•
Do not use adapters for plugging the unit in.
•
Make sure that the power cord is properly inserted
into the corresponding connector of the unit body
and the socket.
•
Use only the supplied power cord, do not use the
power cord of other units.
•
To avoid fire, do not use adapters for connecting the
unit to the mains.
•
Place the unit on a flat heat-resistant surface away
from sources of moisture, heat and open flame.
•
Place the unit with free access to the mains socket.
•
Use the unit in places with proper ventilation.
•
Do not expose the unit to direct sunlight.
•
Do not place the unit close to walls and furniture.
The gap between the multicooker body and the wall
should be at least 20 cm and 30-40 cm above the
multicooker.
•
Provide that the power cord does not contact with
hot surfaces and sharp furniture edges. Avoid dam-
aging the isolation of the power cord.
•
Do not touch the power cord or power plug with wet
hands.
•
Never pull the power cord, when disconnecting the
unit from the mains, take the power plug and care-
fully pull it out of the socket.
•
Do not use the unit near containers filled with water,
next to a kitchen sink, in wet basements or near a
swimming pool.
•
Do not immerse the unit, the power cord and power
plug into water and other liquids.
•
If the unit was dropped into water, unplug it imme-
diately by taking the power plug out of the mains
socket. Do not put your hands into water! Apply to
the authorized service center for the further use of
the unit.
•
Do not insert foreign objects into the openings of the
unit or between its parts.
•
Provide that edges of clothes or foreign objects do
not get between the lid and multicooker body.
•
Use the supplied removable parts only. Do not leave
the operating unit unattended, always switch the unit
off and unplug it when you are not using it.
•
Do not leave the unit lid open during operation,
except when operating in «Roasting» mode.
•
When the unit is operating in «Roasting» mode, do
not bend over the multicooker bowl to avoid burns
by splashing hot oil.
•
To avoid burns do not bend over the steam release
opening and open lid. Be very careful when open-
ing the multicooker lid during and after the cooking.
Danger of burns by hot steam!
3
ENGLISH
24.12.2013 9:41:23