Installation And Connection - Oase ProMax Pressure 6000/8 Gebrauchsanleitung

INSTALLATION AND CONNECTION

Connecting the pressure hose
An optimum flow rate is achieved with a
hose inside diameter of 25 mm (1").
How to proceed:
 B
1. Remove the protection cap.
2. Connect the pressure hose to the con-
nection on the pressure side.
– Recommendation: Use a quick-re-
lease coupling.
Installing the pump in a bored well or
shaft
 C
 Attach the fixing rope with a double knot
to the handle and lower the pump into
the bored well or shaft.
 Use the fixing rope to fix the pump at a
height of at least 0.5 m above the bot-
tom of the well or shaft.
– This prevents it from drawing in dirt
particles.
 Ensure that the screen on the suction
side is at least 150 mm below the sur-
face of the water.
Do not carry the pump by its power con-

nection cable.
 From a well or shaft depth of 5 m, fix the
power connection cable to the fixing
rope at a distance of 5 m from the pump
(strain relief).
Vertical installation of the pump with
the stand
(Only ProMax Pressure 6000)
The pump can be vertically installed with
the stand in a tank or well.
 Ensure that the screen on the suction
side is at least 150 mm below the sur-
face of the water.
Ensure that the water to be pumped

does not contain more than 50 g sand
per m water.
3
How to proceed:
 D
1. Push the mounting feet onto the stand.
2. Undo the Allen screws until the opening
of the stand is wide enough to fit onto
the pump.
3. Push the pump into the stand.
4. Tighten the Allen screws until the pump
is fixed in the stand.
Horizontal installation of the pump
with the stand
(Only ProMax Pressure 6000)
The pump can be horizontally installed
with the stand in a shallow tank or well.
 The pump has to be aligned exactly hor-
izontally.
 Ensure that the water to be pumped
does not contain any sand.
DE
EN
FR
NL
ES
PT
IT
DA
NO
SV
FI
HU
PL
CS
SK
SL
HR
RO
BG
UK
RU
CN
13