Basic Operation Of The Web Application; Starting The Web Application; Selecting The Language Of The Web Application - G&D DL-DVI-Vision-CAT Installation Und Bedienung

Configuration

Basic operation of the web application

The web application provides a graphical user interface to configure and
Config Panel
monitor the KVM extender.
The web application can be used in the entire network independently from the loca-
tions of the devices and consoles connected to the KVM system.
NOTE:
The separate manual provides information about system requirements, the
required configuration of the network interfaces at the
and the operation of the web application.

Starting the web application

How to start the
1. Enter the following URL in the address bar:
https://[IP address of the user or computer module]
2. Enter the following data in the login mask:
Username:
Password:
IMPORTANT: Change the administrator account's default password.
To do this, log into the web application with the administrator account and
then change the password.
The default access data to the administrator account are:
 Username:
 Password:
3. Click on .
Login

Selecting the language of the web application

NOTE: The selected language is saved in the user settings of the active user. The
next time this user logs on, the previously selected language setting is applied.
How to change the default language of the web application:
1. Click on the
country flag
A submenu opens displaying all supported languages in the form of
flags.
2. Change the language by clicking on the desired
21 · G&D DL-DVI-Vision-CAT
Config Panel
web application:
Enter a username.
Enter a password for your user account.
Admin
4658
at the top right.
DL-DVI-Vision-CAT
.
flag
devices