Herunterladen Inhalt Inhalt Diese Seite drucken

IKEA UPPLEVA Handbuch Seite 37

Vorschau ausblenden Andere Handbücher für UPPLEVA:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

continue. If it is not successful repeat
this step.
Note:
─ This TV can memorise the available
networks so it can connect to the
network even if it has been powered
off.
b) Manual. If you want to search for a
specific network.
- Select Manual and press OK. You will
be asked to enter the name (SSID)
of the wireless router you wish to
connect to. If you select a protected
network you will have to enter the
corresponding password. Press OK
on the remote control to display the
virtual keyboard where you can enter
the password using
OK. Select OK to leave the virtual
keyboard and confirm the password
by pressing > Next. If the connection
is successful press > Next again to
continue. If it is not successful repeat
this step.
c) Auto. If your network supports WPS
(Wi-Fi Protected Setup). You can
connect to the network via PBC (Push
Button Configuration) if your router
has a PBC push button, or with a PIN
(Personal Identification Number).
The PIN should only be chosen if you
have a PIN on your router. WPS will
automatically configure the SSID and
WPA key in either mode.
- Select Auto and press OK.
- PBC: Select PBC and press OK to
enter. Press the PBC push button on
your router within 2 minutes. Press
OK on the remote control again.
Your TV will acquire all the network
setting values it needs and connect
automatically to your network.
- Once connected press MENU on
the remote control to go back to the
Network settings menu.
- PIN: Select PIN and press OK
to enter. Enter the PIN code of
your router. Make sure this code is
installed on the network. (Refer to
your router manual.) Press OK on the
remote control again to set up the
connection.
- Once connected press MENU on
the remote control to go back to the
Network settings menu.
/
/ /
and
5. Select Connection test and press OK
to check the internet connectivity. If it
does not work, follow the next step.
6. Select Options > Network settings
> IP setting and press OK to enter
the IP setting menu. You can set
Address type to Auto if you want the
TV to acquire and enter the needed IP
address automatically, or Manual if you
want to enter your IP address manually.
Use
/
to move from one entry field
to another and enter the IP address,
Subnet mask, Default gateway,
Primary DNS and Secondary DNS
values using the number buttons.
7. If you want to see information about
your current connection, such as
Interface, Address type, IP address,
etc., select Options > Network
settings > Information and press OK.
Network cable connection
If you prefer you can also connect a network
cable to the LAN port on your TV. You can
connect your TV to your home network
using the network cable in three ways:
 You can connect your TV to your home
network by connecting the LAN port on
your TV to an external modem using a
network (Cat 5) cable.
 You can connect your TV to your home
network by connecting the LAN port
on your TV to an IP Sharer which is
connected to an external modem. Use a
network cable for the connection.
37

Quicklinks ausblenden:

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis