IKEA UPPLEVA Handbuch Seite 28

your router has a PBC push button, or
PIN (Personal Identification Number).
The PIN should only be chosen if you
have a PIN on your router. WPS will
automatically configure the SSID and
WPA key in either mode.
- Select Auto and press OK.
- PBC: Select PBC and press OK to
enter. Press the PBC push button on
your router within 2 minutes. Press
OK on the remote control again.
Your TV will acquire all the network
setting values it needs and connect
automatically to your network.
- PIN: Select PIN and press OK to
enter. Enter the PIN code of your
router. Make sure this code is
installed on the network. (Refer to
your router manual.) Press OK on the
remote control again to set up the
connection.
7. To set up a network cable connection
(wired).
- You can set Address type to Auto if
you want the TV to acquire and enter
the needed IP address automatically,
or Manual if you want to enter your
IP address manually. Use
move from one entry field to another
and enter the IP address, Subnet
mask, Default gateway, Primary
DNS and Secondary DNS. Use /
to move to each row so you can
enter the correct numbers. Press
OK to go back to the table and use
/ to choose another row. Enter
numbers using the number buttons.
Once everything is entered, press
OK to continue. If the connection
is successful, press >Next again to
continue with the wizard. If it is not
successful repeat this step.
Now it is time to install your TV
channels. If you want to do this later
you can choose Skip scan instead
of Scan. In this case you can install
your TV channels via the menu
later on (See Chapter 7 Options and
settings – Search for TV channels).
8. Press / to select the way you get
your signal (your Tuner mode)
Antenna or
(Note: Satellite option may not be
available for certain models.)
/
Cable or Satellite.
Follow a), b) or c) below depending on
how you get your TV signal.
a) If you have selected
Press OK to enter.
Press
Analogue or Digital or Analogue,
then press OK.
Press
OK to start the automatic search for
all digital (DVB-T) and/or analogue
channels.
b) If you have selected
Press OK to enter.
Press
Analogue or Digital or Analogue.
If you select Digital & Analogue, press
OK to enter. Then:
Press
OK.
Press / to select the scan mode if
available (Full or Advanced).
If you select Full, press OK to start
the automatic search for all digital
(DVB-C) and/or analogue channels.
If you select Advanced, use the
number buttons to adjust the values
for Frequency, Symbol rate and
to Network ID, and use / to select
the Modulation mode; then press
OK to start the search for all digital
(DVB-C) and/or analogue channels.
If you select Digital, press OK to enter,
then follow the same steps as for
Digital & Analogue above, to search
for all digital (DVB-C) channels.
If you select Analogue, press OK to
enter, press
then press OK to start the search for
all analogue channels.
c) If you have selected
Press OK to enter.
Press
press OK.
Press
press OK to configure the information
related to this satellite. Press OK to
go back after finishing the settings.
Press
Note: To prevent the channel setup
process from being interrupted, wait for
/ to select Digital &
/ to select Scan, then press
/ to select Digital &
to select Scan, then press
/
/ to select Scan,
Satellite.
/ to select an operator and
/ to select a satellite, then
to start scanning.
28
Antenna.
Cable.