Safety And Compliance Information; Safety Precautions - Rimage AutoPrinter RAS25 Benutzerhandbuch

Important Information

Safety and Compliance Information

This manual and the indications on the product allow proper and safe
operation. The indication marks below help protect you and other persons
from injury, and equipment from damage.

Safety Precautions

This manual and the indications on the product allow proper and safe
operation. The indication marks below help protect you and other persons
from injury, and equipment from damage.
Warnings!
n
•
Use of controls or adjustments or performance of procedures other than
those specified herein may result in hazardous radiant exposure.
•
Do not disassemble or use tools on a Rimage printer. All service procedures
should be performed by a Rimage-authorized technician, or sent in for
Rimage-authorized repair.
•
Do not service a Rimage printer with the power cord plugged in the AC
outlet.
•
The interior of a Rimage printer contains sharp edges.
•
Do not use a Rimage printer if it is overheating or an abnormal smell is
detected. This may result in a fire and an electric shock. In case of heating
or abnormal smell, immediately disconnect the cable from the outlet.
Contact your Rimage-authorized dealer for repairs.
•
The front bezel of the Rimage Everest™ printer can be opened by hand. Do
not insert your fingers.
•
Do not touch the heat roller in a Rimage Everest printer.
110656_N
n
For more information visit rimage.com/support
Cautions:
• All equipment with AC line voltage, or low DC voltages, such as switches,
power supplies, fuses, fans, non-stepper motors, must be replaced with
Rimage-approved components to maintain the safety approval issued by
UL.
• Use only the supplied AC power cord. For more information or to order a
new power cord, contact Rimage Customer Service.
• This product is designed for an office environment.
• Allow sufficient free space for opening the printer tray. Do not touch the
printer tray while it is moving.
• If the side cover on the Rimage Everest printer is opened while power
is supplied, the printer will stop. Do not reach into the printer while it is
operating. Do not attempt to bypass the door interlock.
• The Rimage Everest printer has no power switch. Power is disconnected
completely by unplugging the cable. Rimage recommends installing the
printer in a position that allows immediate disconnection of the power
cable. Always hold the plug when disconnecting the cable from the outlet.
• The Rimage Everest printer has a voltage slide switch on the back of the
unit. Before use, make sure that it is set to the correct voltage. Please do
not use any voltage other than 110VAC or 220VAC. This could result in a fire
and an electric shock.
3