request the services of a qualified technician.
If current dispersion occurs on contact with metal parts of the machine, turn the main
switch off, unplug the unit from the socket interlocked with switch and call the manufactu-
rer or authorised dealer to request the services of an electrician.
19. SCRAPPING THE MACHINE
At the end of its life, the machine must be disposed of in compliance with current local regu-
lations concerning industrial and special waste. It must also be made unserviceable by cut-
ting the electrical power supply cable, after disconnecting it.
In particular, do not allow the gas contained in the refrigeration system to be dispersed in
the environment; it must be taken to special refrigeration gas recovery centres.
20.ORDERING SPARE PARTS
Find out the code of the part that needs replacing.
Always provide the following information when ordering:
•
Machine serial number (on the plate)
•
Part reference number and code
•
Quantity required
•
Year of manufacture of the machine
•
Most appropriate means of shipment
•
Customer's address
The technical information provided in this manual is intended as a guide. The manufactu-
rer reserves the right to make changes at any time without notice.
28
Rev.01 – 11/11