Technical Support Service; Emergencies - Enofrigo Miami Mini Bedienungsanleitung

Water on the bottom
of the machine.
The lighting or
ventilation do not
work..
The displayed
temperature is not in
conformity with the
real one.
The thermoregulator
does not work
correctly.
Gurgling and blowing noises caused by the refrigeration circuit are normal..

TECHNICAL SUPPORT SERVICE

You are advised to contact the manufacturer or authorised dealer who will carry out any
overhauling and repair work via specialist personnel using purposely designed equipment.
The data given in the identification plate (see chapter n° 5) must always be communicated
to the technical support service, in particular:
•
the type of fault;
•
the machine model;
•
the machine serial number;
•
your address;
•
your telephone number.

18. EMERGENCIES

Correct use of the machine ensures that emergency situations cannot occur during opera-
tion, cleaning and maintenance provided that the instructions given in this manual are fol-
lowed.
In the event of imminent danger, turn the main switch off, unplug the unit from the
socket interlocked with switch and call the manufacturer or authorised dealer to
27
The defrosting water outlet is clogged.
The machine is not plugged into the
current socket.
The power supplì cable is damaged or
interrupted.
The mains bipolar switch is off.
Power failure on controls.
The light or ventilations witch is off.
Light is damaged or interrupted.
The probe is not properly set.
The set values are not correct.
chapter 13.
Check that there are no impurities on
the drainer.
Plug the machine in correctly.
Check the condition of the.
compressor. If necessari contact a
qualified technician to replace it with
another one of the same type.
Turn the mains bipolar switch on.
Check the condition of the controls If
necessary,contact a qualified technician
to restore the current.
Turn the light or ventilations witch on.
Check the condition of the.
lighting. If necessari contact a qualified
technician to replace it with another one
of the same type.
Set probe 1.
Reset the thermoregulator.
Rev.01 – 11/11