Operation - EuroLite DYNAMIC FAZE 1000 Bedienungsanleitung

Operating conditions
Prior to transportation, allow the machine to cool down and completely empty the tank.
Never operate the fog machine without fog fluid. Fire hazard due to overheating! Besides, the unit may
be damaged.
During operation smoke emission may stop. In this case the device is heating up again. After a short
period, the machine will be ready to emit fog again. This process guarantees an appropriate
vaporization temperature and the best fog emission possible. The temperature is regulated by a high-
quality thermostat.
The cable remote provided allows operating the machine in three modes (manual mode, continuous mode and
timer mode). With the wireless remote control it is possible to activate the fog output via radio over a distance of
25 meters. Alternatively, the machine can be controlled with a DMX controller. DMX control will take priority over
remote control operation. The control panel allows the user to adjust the DMX starting address, output volume,
wireless remote control and fluid sensor.
Switching on/off
• Prior to switching on, check the fluid level of the tank and fill up fog fluid, if required.
• Connect the machine to the mains with the power plug.
• Switch on the machine with the power switch. The display flashes and indicates "
machine starts the warm-up process.
• While the machine is warming up, fog output will not be possible yet. Program the necessary menu settings with
the control panel. Once the warm-up process is completed, the display stops flashing and fog output will be
possible.
• After operation, switch off the machine with the power switch.
Notes
• All fog machines develop condensation around the output nozzle. Because this may result in some moisture
accumulation on the surface below the output nozzle, consider this condensation when installing your unit.
• All fog machines may sputter small amounts of fog occasionally during operation and for a minute or so after
being turned off.
• All fog machines have a recycling period after long bursts when the machine will shut itself down for a short
period in order to heat up again. During this time no fog can be produced.
• If you experience low output, pump noise or no output at all, disconnect from mains immediately. Check the fluid
level, the external fuse, the thermo fuse and the power supply. If all of the above appears to be ok, reconnect the
unit again. If fog does not come out after holding the MANUAL FOG button for 30 seconds, check the tube
attached to the tank to make sure there is fluid going through it. If you are unable to determine the cause of the
problem, do not simply continue pushing the button, as this may damage the unit. Return the machine to your
dealer.

OPERATION

CAUTION!
20 • EN
". At the same time, the