Gaggia Baby Twin Gebrauchsanweisung Seite 20

Using Coffee Pods
To use coffee pods, remember to only use the "Perfect crema"
pod fi lter (10).
N.B.: If present, remove the "Perfect crema" filter for ground
coffee (11).
1 Follow the procedure described under "Prepara-
tion".
2 Insert the frothing jet device (13) into the filter holder
(9). Then, insert the "Perfect crema" pod filter (10).
3 Insert the fi lter holder (9) into the brew group (14) from
the bottom and wait for it to heat up.
4 Place a container under the fi lter holder (9). Preheat the
fi lter holder by pressing button (6) (this operation is
only necessary for the fi rst coffee).
Water will start coming out.
5 After dispensing 150 cc of water, press button (6) again
to stop dispensing.
6 After the warming phase, remove the fi lter holder (9) and
insert the pod; make sure the paper of the pod does not
overhang the fi lter holder.
7 Insert the fi lter holder into the machine with a 45°
movement towards the left.
8 Rotate it to the right to tighten it into position. The filter
holder handle shall be perpendicular to the machine or
slightly tilted towards the right.
9 Place a cup under the fi lter holder. Press the button
corresponding to the stored coffee dose.
Coffee will start coming out.
10 On reaching the preset level (see "Coffee dose
programming"), the machine will automatically stop
brewing coffee. It is nevertheless possible to interrupt
coffee brewing by pressing the previously selected button
(2 or 3).
A good coffee, prepared with the right procedure, will
show the typical brown "crema".
If this is not the case, please refer to "In the event of
faulty function".
11 Remove the cups and serve.
12 To brew more coffee, slowly remove the fi lter holder with
caution, moving it towards the left. Make sure to not get
burnt with the water from coffee grounds. Once the fi lter
holder has been removed, some water will still drop.
This is due to the water pressure in the system. Remove
the grounds from the fi lter. To brew more coffee, repeat
the procedure from step 6 to 11.
Important note: Filters should be kept clean to
guarantee perfect results. Clean daily after use.
If you experience a malfunction in the coffee brewing
process, leave the Filters in a metal container of hot
boiling water for 10 minutes, then rinse them in running
water and perform another brewing.
For a deeper cleaning of the filters, we recommend using
the cleaning tablets specifically designed to maintain the
efficiency of the machine.
• 17 •
ENGLISH