Chal-Tec 10004566 Bedienungsanleitung Seite 39

SMTP Port:
indicates sender port of SMTP server. Generally the SMTP port value is 25, but there are exceptions, for
example, SMTP port of G-mail server should be 465.
SMTP server:
indicates server address you use.
Sender email:
indicates sender's email address. The email address should be consistent with the server you use. That is to
say, when you use email address – aaa@gmail.com, the according server should be smtp.gmail.com.
Receiver address:
indicates receiver's email address. The email address is used to receive image transmitted from motion
detection alarm of DVR. Please clear the images you have received as soon as possible to avoid overloading
your email account. For detailed SMTP protocols settings refer to the below picture 5-36.
PTZ Setup
Enter into [Main menu  Device  PTZ Setup] to select the PTZ
channel you want to control and set PTZ protocol (Pelco-D, Pelco-P),
Baud rate (1200, 2400, 4800, 9600), Data bit (8, 7, 6, 5), Stop bit
(1, 2), Parity Check (None, Odd, Even Mark Space) and address
code respectively. Please note the above-mentioned channel
settings must match the settings of the PTZ camera.