Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Mouse Operation
You can use a mouse instead of front panel buttons or remote control.
In menu lock mode, Enter into pop-up menu and clicking any sub menu to pop up Log-in window; on menu
unlock mode, enter into pop-up menu, and then clicking left key to enter into any sub menu directly. After
entering main menu, clicking left key could enter into any sub menu; On[Detailed file] menu mode, clicking
left key could playback one recording file.
Change the status of check box and motion detection area. Clicking combo box to access pull-down menu.
By clicking left key you can adjust Color control bar and volume control bar.
By clicking left key you can select values in edit boxes or pull-down menu and supports Chinese word input,
special symbol, numeric and character input, use instead of [Enter- ] or [Backspace ]
Click left key of Mouse
In the [Detailed file] menu mode, clicking left key will playback one recording file.
In live display mode, clicking Click right key of right key will display pop-up menu (shown as Picture 5-1).
Mouse In Main menu or sub menu mode, clicking right key will exit current menu.
Double-click Left key of Mouse
In live display or playback mode, double-clicking left key will maximize the screen.
Moving Mouse Select menu item
Sliding Mouse On motion mode, sliding mouse will select motion area; On [Color set] menu mode,
sliding mouse will adjust color control bar and volume control bar.
DVR Installation
Hard Drive Installation
Caution: Please do not Install or take out hard drive when DVR is running!
(1) Remove screws and open DVR upper cover carefully;
(2) Insert Power Cord and data cable into Pin of hard drive securely;
(3) Put the upper cover back carefully, re-attach screws.
Camera and Monitor Connection
Connect camera cable to video input of DVR, and from video output of DVR to Monitor via BNC connector
(Refer to section2.2-Rear Panel); or If the camera is a PTZ speed dome, you could connect RS485 A & B to
the according port of DVR respectively (refer to system figuration on Chapter 8).
Power Supply connection
Please only use the power adapter supplied with the DVR .
DVR Boot up
System Initialization
After connecting the power adapter and turning On the power button, the system will boot-up and start
initializing.
Main Interface
After finishing system initialization you are allowed to enter into main interface. The picture4-2 is the main
interface faulted by system, which is under no video input status. Once there are any video inputs, the
interface will display live images accordingly for relative channels. On main interface mode, when double-
clicking live image of any channel, the image will be maximized to full screen, then double-clicking again, will
be come back to quad display; when clicking right key of mouse, allow you enter into Pop-up Menu; when
clicking left key of mouse, allow you select menu item; when clicking any area outside menu, allow you exit
the Pop-up menu.
Pop-up Menu
After finishing system initialization, click right key of mouse on main interface mode to enter into Pop-up
Menu. Now you could proceed parameter setting and operate for Main Menu, Menu lock, Recording search,
PTZ control and recording etc.
Werbung
Inhaltsverzeichnis
