Adjusting The Handle Height; Adjusting The Cutting Height - Toro 21680 Bedienungsanleitung

Adjusting the Handle
Height
You may raise or lower the handle to a position
comfortable for you.
Rotate the handle lock, move the handle to 1 of 3
positions, and lock the handle into position
1. Handle lock
(Figure
Figure 11
2. Handle positions
Adjusting the Cutting
Height
Adjust the cutting height as desired. Set all the
cutting-height levers to the same height. To raise and
lower the machine, refer to
11).
1. Cutting-height lever
Important:
The cutting height settings are 25 mm
(1 inch); 38 mm (1-1/2 inch); 51 mm (2 inches); 64
mm (2-1/2 inches); 83 mm (3-1/4 inches); 95 mm
(3-3/4 inches); 108 mm (4-1/4 inches).
g007284
9
Figure 12.
Figure 12
g012130