Cleaning Under The Machine; Folding The Handle - Toro 21680 Bedienungsanleitung

Cleaning under the Machine

Service Interval: Before each use or daily
For best results, clean the machine soon after you
have completed mowing.
1. Lower the machine to the lowest cutting-height
setting. Refer to
(page 9).
2. Move the machine onto a level surface.
3. Attach a garden hose that is connected to a
water supply to the washout port
Figure 19
1. Washout port
4. Turn the water on.
5. Start the engine and run it until there are no more
clippings that come out from under the machine.
6. Shut off the engine.
7. Shut off the water and disconnect the garden
hose from the machine.
8. Start the engine and run it for a few minutes to
dry the underside of the machine.
9. Shut off the engine and allow it to cool.

Folding the Handle

WARNING
Folding or unfolding the handle improperly
can damage the cables, causing an unsafe
operating condition.
• Do not damage the cables when folding or
unfolding the handle.
• If a cable is damaged, contact an
Authorized Service Dealer.
1. Loosen the handle knobs.
2. Rotate the entire handle forward
Adjusting the Cutting Height
(Figure
(Figure
Important:
of the handle knobs as you fold the upper
handle.
19).
3. Rotate the upper portion of the handle back
toward the engine; refer to
g014538
1. Handle knobs
20).
14
Route the cables to the outside
Figure 20
Figure 21.
Figure 21
g020722
g020721