Private Exchanges; Outside Line Code - switel D7210 Bedienungsanleitung

7

Private exchanges

You can use the "R" signal button
If you have connected your telephone to a private exchange, you can use all the
facilities such as call transfer, automatic recall, etc. The "R" signal button gives you
access to these facilities. The FLASH time "100ms" will be required on a private
exchange. You can find out from the dealer from whom the equipment was purchased
whether your telephone will work on your private exchange without any problems.
7.1

Outside line code

With private exchanges, it is necessary
to dial a certain number (e.g. "9" or
"0") in order to obtain a dialling tone for
an outside line on the extension. With
some, older private exchanges, it
takes some time before the dialling
tone can be heard.
Especially for these private
exchanges, an automatic pause can
be inserted after connecting to the
outside line so that you can dial
directly without waiting for the dialling
tone.
Special note: If you have not
connected your telephone to a private
exchange or if your private exchange
works without a pause or without
connecting to an outside line, please
do not enter any settings in this area.
132
- Private exchanges -
on your telephone on private exchanges.
Button
2 x
1 x
3 x
1 x
Display
PHONEBOOK
BASIS
?
RINGER
ADVANCED
?
PIN (Factory setting 0000)
CALL BAR
PABX PAUSE
?
PBX CODE
Insert number or delete
existing numbers with
PBX CODE
PAUSE
?
3 or 5 SECONDS
Select required pause
RD
?
PAUSE
Press and hold button