Setup Menu - VOLTCRAFT IR-2200-50D USB Bedienungsanleitung

4. The computer automatically detects a new device. Insert the supplied software CD into a CD drive
and follow the installation instructions on the screen. Let the computer search for the new driver
automatically.
5. After successful installation, you may start the software.
6. To deactivate the USB interface, press the button in MAX, MIN, DIF or AVG mode until the USB
symbol vanishes from the display.
When the USB interface is activated, the infrared and measured contact temperature
values may be transferred to a computer. In connection with the LOCK function and the
included software, this enables you to establish a long-term temperature record. For
further information, refer to the software help menu.
Contact temperature measuring function
In addition to the infrared measuring function, the device has a contact temperature measuring
function. In addition to the included wire temperature sensor, all traditional type K temperature sensors
with a mini plug can be connected to the device.
When you connect a type K temperature sensor with a mini plug to the type K temperature sensor
socket, "TK" will be displayed in MAX, MIN, DIF or AVG mode when the device is switched on. When
the measuring button is pressed, the measured contact temperature is displayed at the bottom of
the display.
Observe that contract temperature measurement must only be conducted
for standing objects that are free of voltage. Also observe that only contact
temperatures up to the sensor's permissible temperature are allowed. The
permissible temperature of the included wire sensor is -50 to +250 °C.

Setup menu

The setup menu allows you to select, activate or set the different
functions of the device. The following illustration is a schematic of the
settings menu. Use the "MODE" button to navigate within the menu.
Use the "▲" and "▼" buttons to make adjustments.
Max, Min, difference and average function (MAX / MIN / DIF/ AFG)
1. Press the measuring button to switch on the measuring device.
2. Press the "MODE" button until one of the MAX/MIN/DIF/AFG/LOG symbols flashes in the display.
- MAX (Device shows the highest value measured during the measurement in the top of the
display)
MIN
- (Device shows the smallest value measured during the measurement in the top of the
display)
27