Clas Ohlson FS40-16JA Bedienungsanleitung Seite 5

Assembling the fan head
1. Undo the locking ring and
extend the pedestal tube.
Tighten the locking ring again.
2. Undo Screw A and
place the fan head onto
the pedestal tube. Tighten
Screw A.
3. Undo the locking ring and
adjust the fan to the desired
height. Tighten the locking
ring again.
Fitting the fan blade and safety grille
1. Remove the lock
nut (5) from the rear
safety grille.
2. Pass the rear grille
(6) over the drive
shaft on the front of
the motor and align it
on the locating pins.
3. Secure the rear grille using the rear grille lock nut.
4. Thread the fan blade onto the motor drive shaft. Tighten the lock nut (3).
5. Align the front safety grille (2) with the rear
safety grille and fasten the two halves of
the grille together using the four clips.
6. Lock the two halves of the grille together
using the included screw and nut in
the hole on the top edge of the grille.
Pedestal
extension
tube
Locking ring
Grille nut Locating pins
5
Screw A