I Ending The Cleaning Cycle - Zodiac Vortex RV 4200 Montage- Und Gebrauchsanleitung

3.6 I Ending the cleaning cycle

• To prevent damaging the equipment :
Do not pull on the cable to remove the appliance from the pool. Use the handle.
-
- Do not leave the appliance to dry out in sunlight aft er use.
- Store all the elements away from sunlight, humidity and bad weather.
- Screw the protecti ve cap back on if you unplug the control box power cord.
• Switch off the appliance by pressing
• When the cleaner is within arm's reach, pick it up by the handle and lift it gently out of the pool so that the water it
contains drains into the pool (see image
• Place the cleaner verti cally in the locati on provided on the caddy (depending on the model) for it to dry out quickly
(see image ).
• Then store it with the control box away from sunlight and any splashes. A protecti ve cover is available as an opti on
(see image ).
3.6.1 "Remove from pool" mode
This functi on enables the cleaner to return to an exact point at the edge of the pool. When it climbs the wall, the cleaner
sprays a jet of water behind it to make it lighter as it exits the pool.
• Direct the cleaner towards the required pool wall, then make it climb to the water line: hold
The cleaner moves towards the wall when you release the butt on.
Tip to prevent the fl oati ng cable from becoming tangled
The cleaner's behaviour is strongly impacted by the tangling of the cable. A cable that is correctly untangled
will guarantee bett er coverage of the pool.
• Untangle the cable and lay it out in the sun so that it returns to its original shape.
• Then wind it up carefully and place it on the caddy handle (depending on the model) or on a fi xed support.
11
.
).
(depending on the model)
down to rotate it.