Sony MG10-P1 Bedienungsanleitung Seite 79

Operation commands
For the same commands as the setting commands (see the list of
operation commands), refer to section 5-4 for details on how to set
the commands.
Command Description
P-P Switch to the peak-to-peak value mode.
Command format
12P-P
MAX Switch to the maximum value mode.
Command format
12MAX
MIN Switch to the minimum value mode.
Command format
12MIN
REAL Switch to the current value mode.
Command format
12REAL
RCL Recall the preset values.
Command format 12RCL
RES Reset
12RES
(zero reset/reference point setting cancel)
START Start
12START
* Set the current value established when the
command is input as both the maximum
and minimum values (zero for the peak-
to-peak value), and start the peak value
measurement.
MG10-P1 / MG10-P2
Command Description
PAU Set the peak value data update stop.
Command format 12PAU3
3= ON : Peak value data update stop
OFF : Peak value data update stop cancel
LCH Set the current value data latching.
Command format
12LCH3
3= ON : Current value output data latch stop
OFF : Current value output data latch stop cancel
L Load the reference point.
Command format
12L
Read commands
Command Description
LO=? Load the reference point offset value.
Command format
12LO=?
Return format
12LO=3
3= Setting _99.9999 to +99.9999
VER=? Read the software version.
Command format
1VER=?
Return format
1VER=3
3= Version No.
* Starting from the leading byte: major
version, minor version
(Example) "0VER=10"
31
(E)