Sony MG10-P1 Bedienungsanleitung Seite 72

Setup commands
Command Description
Write/Read
SETUP Start parameter setup.
Command SETUP
Starts parameter setup.
MODE=/MODE=? Set the measuring mode.
Command/
12MODE=3
Return format 3= 0 : Current value (REAL) mode
1 : Maximum value (MAX) mode
2 : Minimum value (MIN) mode
3 : Peak-to-peak value (P-P) mode
P=/P=? Set the preset value.
Command/
12P=3
Return format 3= The value differs depending on the
input resolution.
Resolution Setting
0.1 um _99.9999 to +99.9999
0.5 um _99.9995 to +99.9995
1 um
5 um
10 um _9999.99 to +9999.99
24
(E)
2-digit integer + decimal point + 4 decimal places
(last digit must always be a 5 or 0)
3-digit integer + decimal point + 3 decimal places
_999.999 to +999.999
_999.995 to +999.995
(last digit must always be a 5 or 0)
4-digit integer + decimal point + 2 decimal places
Command Description
Write/Read
CH=/CH=? Set the comparator upper limit.
CL=/CL=? Set the comparator lower limit.
Command/
12CH3=4
Return format
12CL3=4
3= 1 : Comparator set number 1
2 : Comparator set number 2
3 : Comparator set number 3
4 : Comparator set number 4
4= The value differs depending on the input
resolution.
Resolution Setting
0.1 um _99.9999 to +99.9999
0.5 um _99.9995 to +99.9995
1 um
5 um
10 um _9999.99 to +9999.99
n
This setting is ignored if the lower limit value is actually larger
than the upper limit value or if the upper value is actually smaller
than the lower value. When changing the setting values, be certain
after changes have been made that the upper limit value is greater
than or equal to the lower limit value.
2-digit integer + decimal point + 4 decimal places
(last digit must always be a 5 or 0)
3-digit integer + decimal point + 3 decimal places
_999.999 to +999.999
_999.995 to +999.995
(last digit must always be a 5 or 0)
4-digit integer + decimal point + 2 decimal places
MG10-P1 / MG10-P2