Installing The Unit On The Din Rails - Sony MG10-P1 Bedienungsanleitung

3-3. Installing the Unit on the DIN Rails

When the multi interface unit is shipped from the factory, the tabs
on the DIN rail anchoring levers are locked.
DIN rail specifications: 35 mm
1
Align the top side of the groove in the unit's rear panel with
the top of the DIN rails.
MG10-P1 / MG10-P2
2
Install the unit by pushing it into position until a clicking sound
is heard so that the bottom side of the groove in the unit's rear
panel fits snugly on the DIN rails.
n
Check that the whole unit has been installed properly.
<When removing the unit from the DIN rails>
While holding the unit in place so that it will not fall, pull down the
DIN rail anchoring levers of all the modules until a clicking sound
is heard.
9
(E)