Operation Commands - Sony MG10-P1 Bedienungsanleitung

6-1-5. Operation Commands

List of operation commands
Command Setting item
R Load the data of all the channels.
r Load the data of specific channels.
P-P Switch to the peak-to-peak value mode.
MAX Switch to the maximum value mode.
MIN Switch to the minimum value mode.
REAL Switch to the current value mode.
MODE Set the measuring
mode.
RCL Recall the preset value.
RES Reset.
(Zero reset/reference point setting cancel)
START Start.
P Set the preset value.
CH Set the comparator
upper limit.
CL Set the comparator
lower limit.
SCN Set the comparator
set number.
PAU Set the peak value data update stop.
LCH Set the current value output data latching.
L Load the reference point.
30
(E)
Remarks
For details on how to set the
measuring modes, see
section 5-4.
For details on how to set this
value, see section 5-4.
For details on how to set
this value, see section 5-4.
For details on how to set
this value, see section 5-4.
For details on how to set this
number, see section 5-4.
Details of command operations
ASCII code is used for all the commands. A command is terminated
C R C R L F C R
by " " or " " + " ". ("
. Select using communication setting switch No. 2. on main unit.
C R " + " L F
OFF : "
C R
ON : " "
. On the pages to follow, "3" and "4" are used to indicate the
value to be set.
. When inputting a setting, a numerical value inside the assigned
range must be selected: otherwise, the value will not be set.
. If no polarity (+ or _) is input, it is construed as +.
[Data which is input ahead of the commands]
Data Selection range Symbol used in descriptions
0 to F or *
Unit number
Module number 0 to F or *
. 0 to F are hexadecimal numbers which are equivalent to 0 to 15
in the decimal system.
. * is used when the settings are to be set for all units or all
modules.
L F
": carriage return; " ": line feed)
" (factory setting)
1
2
MG10-P1 / MG10-P2