Disposal And Recycling; Care And Maintenance - Scheppach 7906100715 Originalbetriebsanleitung

leave the device.
• Another alternative is to keep the mouth (9) pressed
against the workpiece.
• Each time the trigger (2) is actuated, a fastener will
leave the device.
Removing jammed fasteners
• If a staple or nail gets jammed in the magazine slot,
immediately disconnect the compressed air supply.
• Open the magazine (6) as described in the chapter
"Loading the magazine".
• Open the face plate (10) by pulling the face plate
quick clamping lever (11) in the direction of the trigger
lock (8) .
• Remove the jammed fastener.
• Close the face plate (10) by pulling the face plate
quick clamping lever (11) in the direction of the ex-
haust air aperture (1) .
• Close the magazine (6) of the compressed air tacker
as described in the chapter "Loading the magazine".

Care and maintenance

Important: Disconnect the equipment from the com-
pressed air system each time before starting to carry
out maintenance and cleaning work.
Compliance with the maintenance instructions given
here will ensure that this quality product has a long
service life and offers failure-free operation.
Before starting work each time, check that the magazi-
ne is securely fastened (6). Clean the equipment tho-
roughly immediately after you have finished the work.
To ensure that your stapler offers lasting perfect ser-
vice, it requires regular lubrication. Use the supplied
oil for this purpose.
There are two possible means of lubrication:
By mist oiler
A complete conditioning unit contains a mist oiler and
is fitted to the compressor.
By hand
If your system has neither a conditioning unit or a line
oiler, 3-5 drops of oil have to be applied to the com-
pressed air connection each time before the air tool is
started up. If the air tool is not used for several days,
apply 5-10 drops of oil to the compressed air connec-
tion before switching on.
Store your air tool in a dry room only.
Other maintenance work
There are no parts inside the equipment which require
additional maintenance.
Cleaning
• Do not use any sharp objects to clean the device.
Do not allow any liquids to enter the device. Other-
wise the device could be damaged.
• Clean the device regularly, preferably always imme-
diately after finishing work.
• Use a dry cloth to clean the housing. Under no cir-
cumstances should you use petrol, solvent or clea-
ners which attack plastic.
• After each use, pack the compressed air tacker in
the carrying case it was delivered with to protect it
from dirt.
10 І 48
 www.scheppach.com  service@scheppach.com  +(49)-08223-4002-99  +(49)-08223-4002-58

Disposal and recycling

The equipment is supplied in packaging to prevent it
from being damaged in transit. The raw materials in
this packaging can be reused or recycled. The equip-
ment and its accessories are made of various types of
material, such as metal and plastic. Defective compo-
nents must be disposed of as special waste. Ask your
dealer or your local council.