Herunterladen Inhalt Inhalt Diese Seite drucken

Dangers; Safety; Connection And Start-Up - H-tronic AL 600plus Bedienungsanleitung

Bleibatterie-lader mit diagnosefunktion und neuester ladetechnik
Vorschau ausblenden Andere Handbücher für AL 600plus:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

Do not operate the device during frost
or danger of frost to avoid the formation
of condensation water. Do not expose
the device to rain or moisture to avoid a
fire hazard and the danger of an electric
shock. Do not allow liquids of any kind to
penetrate into the device.
Never cover the ventilation slots or
housing. Do not place the device near
to warm air sources such as heaters or
the like! Never put or lead the charging
cable near to inflammable materials. The
charging cable may neither be kinked
nor be led over sharp-edged parts. Live
cables or lines, which are connected to
the device, must always be tested be-
fore and after use for insulation faults
or breakages. Immediately discontinue
using the device, if an error is determined
in the supply cable. The device may only
be used on a stable and non-combusti-
ble surface. Only use the device outside
of the vehicle. Ensure a safe and stable
connection when connecting the battery
charging clamps.
Never use in the case of adverse ambient
conditions. Adverse ambient conditions
are: Ambient temperatures below -25 °C
or above +50 °C, combustible gases, sol-
vents, vapours, dust, air humidity above
80 % as well as wetness.
The device may only be used in dry and
closed rooms.
Switch the device off immediately and sa-
feguard it against unintentional operation,
if it must be assumed that safe operation
is no longer possible.

3. Dangers

Immediately disconnect the device from
the mains and from the battery, if defects
are recognisable, such as e.g.: Smoke
emission, penetration of liquids etc. Have
the malfunction repaired immediately.
Danger by reverse polarity, short-circuit
and contact with battery acid - always
observed the safety instructions of the
lead battery manufacturer. Caution! Bat-
tery acid is extremely corrosive. Immedia-
tely treat acid splashes on skin or clothes
with a soap solution and rinse with lots
of water. Acid splashes in the eye must
be immediately rinsed with lots of water;
consult a physician immediately.

4. Safety

Provide adequate ventilation in the room
during charging.
Do not open the cell plugs on mainte-
nance-free lead batteries (lead-acid bat-
teries).
Check the acid level before charging non-
maintenance-free lead batteries.
Check the acid level occasionally when
charging non-maintenance-free lead bat-
teries for a longer charging period. Check
the charging procedure regularly for safe-
ty reasons.
Always avoid open flames, open lights
and sparks in the proximity of batteries
being charging (Explosion hazard by de-
tonating gas).
Always observe the charging instructions
of the battery manufacturer.

5. Connection and start-up

Insert the mains cable of the device into
an intact socket, which also complies
with the VDE regulations.
You must ensure that all vehicle power
consumers, such as e.g. ignition, radio,
light, telephone, mobile phone battery
chargers etc. are switched off, if the bat-
tery is charged in a built-in state. The lead
battery must be dismantled or unclamped
8

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis