Working Instructions; Maintenance And Service; Accessories - Bosch 0 607 160 502 Bedienungsanleitung

Working Instructions

Disconnect the air hose from the air supply be-
fore making any adjustments, changing acces-
sories, or storing the tool. Such preventive safety
measures reduce the risk of starting the tool acciden-
tally.
Excess loads that cause the tool to stall or reduce
speed will not damage the motor.
Maintenance
Disconnect the air hose from the air supply before
making any adjustments, changing accessories,
or storing the tool. Such preventive safety measures
reduce the risk of starting the tool accidentally.
Should the tool fail in spite of careful manufacturing and
testing procedures, have the repairs performed by an
authorized customer service location for Bosch electro-
tools.
For inquiries and spare parts ordering, please include
the 10-digit order number on the nameplate of the tool.
Clean the screen of the air inlet regularly. For this pur-
pose, unscrew the hose nipple 7 and remove dust and
dirt particles from the screen. Then firmly remount the
hose nipple (see Fig.
A
To prevent damage to the internal valve components
of the tool, you should use an open end wrench
(22 mm) to apply a counterforce at the protruding con-
nector of the air inlet 5 when screwing/unscrewing the
hose nipple 7.
Water and dirt particles in the com-
pressed air cause rust formation and
lead to clogging of vanes, valves, etc.
To prevent this, a few drops of motor oil
should be placed in the air inlet 5. Re-
connect the tool to the air supply and
let the tool run for 5–10 s while catching the oil that
runs out with a rag. If the air tool is not used for a
longer time, this procedure should always be
performed.
3 609 929 937 • (03.10) T

6 MAINTENANCE AND SERVICE

).
In the event of an interruption of the air supply
or reduced operating pressure, switch off the
tool. Check the operating pressure and start
again when the pressure returns to normal.
Type 0 607 160 509 /... 511
Reversing Rotational Direction
Right rotation: Turn the right/left rotation switch 4 to
Left rotation: Turn the right/left rotation switch 4 to
For all Bosch pneumatic tools that do not belong to
the CLEAN series, you should admix an oil mist to the
flow of compressed air. The compressed air oiler re-
quired for this is located on the compressed air main-
tenance unit connected to the tool.
You should use SAE 10 or SAE 20 motor oil for direct
lubrication of the tool or for admixture at the mainte-
nance unit [compressor].
After approx. 150 hours of operation, the gearbox is to
be cleaned for the first time and then after every 300
hours of operation. After each cleaning, it should be
lubricated with special gearbox grease.
Special gearbox grease 225 ml . . . . . 3 605 430 009
The motor vanes should be routinely inspected by
trained personnel and, if necessary, replaced.
Have maintenance and repair work performed
only by qualified specialists. In this manner, it can
be ensured that the safety of the tool is maintained.
Any Bosch customer service center can perform this
work quickly and reliably.
Dispose of lubricants and cleaning agents in an
environment-friendly manner. Comply with the
legal regulations.

Accessories

All tools can be equipped with key-type or keyless drill
chucks.
Information about the complete quality accessory pro-
gram can be found on the Internet at
www.bosch-pt.com and
www.boschproductiontools.com or at your dealer.
English–7
the right until it stops.
the left until it stops.