Accessories; Technical Data - Hilti WSC 70 Bedienungsanleitung

3 Accessories

Accessories for the WSC 70/ WSC 55
Designation
Parallel guide (rip fence)
Guide rail
Chip ejector

4 Technical data

Right of technical changes reserved.
Rated voltage
Rated power, WSC 70
Rated current, WSC 70
Mains frequency, WSC 70
Rated power, WSC 55
Rated current, WSC 55
Mains frequency, WSC 55
NOTE
Information for users as per EN 61000-3-11: Switching on causes a brief drop in voltage. Other appliances may be
negatively affected when connected to mains supplies where conditions are unfavorable. No malfunctions are to be
expected on mains supplies with an impedance of less than <0.15 ohms.
Power tool
Weight in accordance with EPTA
procedure 01/2003
Supply cord length
Dimensions (L x W x H)
Base plate
Maximum saw blade diameter
Minimum saw blade diameter
Saw blade disc thickness
Kerf width
Saw blade arbour size
Cutting depth
Riving knife thickness
No-load running speed, 220-230 V
No-load running speed, 110-120 V
NOTE
The vibration emission level given in this information sheet has been measured in accordance with a standardised test
given in EN 60745 and may be used to compare one tool with another. It may be used for a preliminary assessment
of exposure. The declared vibration emission level represents the main applications of the tool. However if the tool is
used for different applications, with different accessories or poorly maintained, the vibration emission may differ. This
may significantly increase the exposure level over the total working period. An estimation of the level of exposure to
vibration should also take into account the times when the tool is switched off or when it is running but not actually
doing the job. This may significantly reduce the exposure level over the total working period. Identify additional safety
110 V
1,500 W
14.6 A
50...60 Hz
1,500 W
14.6 A
50...60 Hz
WSC 70
4.9 kg
4 m
340 mm x 265 mm x 277 mm
193 mm x 320 mm
190 mm
176 mm
0.5...1.4 mm
1.6...2.2 mm
30 mm
Cutting angle 90°: 70 mm
Cutting angle 50°: 45 mm
Cutting angle 45°: 51 mm
1.5 mm
5,500/min
5,500/min
Description
WPG 70/55
WGS 1400‑2B
230 V
1,500 W
7.0 A
50...60 Hz
1,500 W
7.0 A
50...60 Hz
WSC 55
4.7 kg
4 m
340 mm x 265 mm x 269 mm
193 mm x 320 mm
160 mm
156 mm
0.5...1.3 mm
1.5...2.2 mm
20 mm
Cutting angle 90°: 55 mm
Cutting angle 50°: 36 mm
Cutting angle 45°: 40 mm
1.4 mm
5,500/min
5,500/min
220 V
1,500 W
7.5 A
50...60 Hz
1,500 W
7.5 A
50...60 Hz
17
en