4.
Tighten the self-locking nuts securely while holding the blade firmly
against the holders.
Be sure that there is no clearance between the scraper and ground
when the snowthrower is placed on the ground, then tighten the
nuts.
Replace the scraper if the auger rubber-to-ground clearance is out of
specification when the holders are installed with the three holes
facing up.
Replacement
The scraper must be replaced if it is worn abnormally or the service
limit is exceeded.
1.
Turn the engine switch off and drain the fuel tank.
2.
Lift the handle so that the auger housing faces down.
3.
Remove the four self-locking nuts, holders and collars from the
scraper, and remove the scraper.
4.
Install a new scraper into the auger housing securely.
5.
Install the self-locking nuts, collars and holders, then tighten the self-
locking nuts securely.
Check that all holders are installed in the same direction.
Be sure that there is no clearance between the scraper and ground
when the snowthrower is placed on the ground, and that the auger
rubber-to-ground clearance is correct, then tighten the self-locking
nuts.
Correct clearance: 0 2 mm (0 0.079 in)
AUGER HOUSING
SCRAPER
42
−
−
BOLT
COLLAR
SCRAPER
HOLDER
SELF-LOCKING NUT