Honda HS621 Bedienungsanleitung Seite 34

5. The snowthrower will move forward as long as the auger contacts
the ground. To stop, push down on the handle to pivot the auger up
and away from the ground, or release the auger clutch lever.
Make sure that the auger clutch lever is functioning correctly. If not,
stop the engine and readjust the auger clutch cable (see page
Clearing snow
· For best efficiency, clear snow before it melts, refreezes and hardens.
Do not reduce engine speed while throwing snow. Observe the
following to clear hard or deep snow.
· Start the snowthrowing operation only after the engine has warmed
up and is running smoothly.
· When you are operating the snowthrower over bumpy ground, push
down on the handle to raise the snowthrowing mechanism above
ground level.
· When the temperature is high, and the snow is wet and heavy,
operate at reduced speed.
· Walk the snowthrower slowly to remove hard or deep snow. Push
handle down and forward for additional traction and overlap each
swath if necessary.
SLOWLY
46 ).
31