Adjustment
1.
Check the auger rubber-to-ground clearance. It should be:
0 2 mm (0 0.079 in)
−
−
If the clearance is out of the specification, turn the engine switch off,
drain the fuel tank, and lift the handle so that the auger housing
faces down.
Gasoline is extremely flammable and is explosive under certain
conditions.
Spilled fuel or fuel vapor may ignite. If any fuel is spilled, make sure
the area is dry before starting the engine.
2.
Loosen the four self-locking nuts and lower the scraper blade fully.
3.
Adjust the auger rubber-to-ground clearance by rotating the holders.
Correct clearance: 0 2 mm (0 0.079 in)
Be sure that all holders are set in the same direction.
The blade is set at its lowest position when the holders are installed
with the three holes facing up.
HOLES
HOLDER
−
−
SELF-LOCKING NUT
SCRAPER
41