Selecting The Temperature - Waeco CoolAir CA-800 Bedienungsanleitung

BA_CA-800.book Seite 26 Dienstag, 9. Februar 2010 12:27 12
Using the roof air conditioner
8.2 Switching on the roof air conditioner
Never close all of the air nozzles of the roof air conditioner simulta-
neously. The device would ice up inside.
The first time the roof air conditioner is used, there may be a slight
smell. This is normal and soon goes away.
➤ With the system switched off, press the ON/OFF button (2 1, page 3).
If you completely switch off the roof air conditioner, it can only be
switched on again using the control panel. The system can only
be switched on using the remote control if it is in standby mode, in
other words switched off using the remote control. If the system
will not be used for a lengthy period, switch it off completely so
that the battery is not wasted supplying standby power.
✓ The fan starts at low speed.
✓ The Power LED (2 8, page 3) lights up.
✓ The digital display (2 5, page 3) shows the selected temperature in °C
and the operating mode (e.g.
20 °C).
The compressor is switched on after a 90-second delay.
8.3

Selecting the temperature

You can select temperatures between 17 °C and 30 °C.
➤ Press + or - (2 6/7, page 3) on the control panel or + or - (3 2/3, page 3)
on the remote control to set the temperature in 1 °C steps.
✓ The digital display (2 5, page 3) shows the operating mode and the se-
lected temperature in °C.
If mode I or II fails to achieve the selected temperature,switch to
the next mode up or to automatic mode.
26
A20 for automatic mode + temperature
CoolAir CA-800