Stop Watch; Memory Feature; Heart Rate Measurement; Warning Light - Crivit 1-LD3945 Bedienungs- Und Sicherheitshinweise

Cd U After reaching 0:00 the timer will count forward
Cd S After reaching 0:00 the timer will stop
Exit setting mode by pressing MODE.
The timer can be started or stopped by pressing SET.
Press and hold SET to reset the timer.
After the timer time is up an alarm will sound.

Stop watch

Press MODE to select the feature before proceeding.
CHRONO CHRONO CHRONO CHRONO ST ST ST ST- - - - UHR UHR UHR UHR
Press SET to start or stop the stop watch. Press SEL while the stop watch is running
to record a lap time. Up to 99 laps can be recorded.
Press and hold SET to reset the stop watch.

Memory feature

DATA ANSICHT
RECALL DATEN
Press SEL while the stop watch is stopped to display the fastest lap on the display.
Press SET to display the other lap times.
Please note: The memory feature can only be used if at least one lap time was
recorded.

Heart rate measurement

Press MODE to select the feature before proceeding.
HRM HRM HRM HRM PULS PULS PULS PULS
The subfeatures of the heart rate measurement can only be used when the chest
belt is connected.
Press SEL to access the subfeatures of the heart rate watch.

Timer

TIMER TIMER
CHRONO CHRONO CHRONO CHRONO CRONO CRONO CRONO CRONO
APPEL RECUP
DONNEES DATOS
FC FC FC FC PULSO PULSO PULSO PULSO
COMPTE TEMPORIZADOR
 - 59 -

Memory feature

MEMORY SPEICHER

Target heart rate

ZONE BEREICH

Calories, fat burn and BMI

CALORIE KALORIEN
Fitness
FITNESS FITNESS
LEVEL LEVEL
In the middle row of the display the heart rate is shown while wearing the chest
belt. If the signal is received from the chest belt the heart symbol will flash. To the
right of the heart rate the heart rate in percent of the maximum heart rate is shown.
The maximum heart rate is calculated by evaluating your age, weight and height.

Warning light

MEMOIRE MEMORIA
ZONE ZONA
CALORIES CALORIAS
NIV FORM NIVEL
PHYSIQ FIT
If your heart rate reaches or exceeds 99% of
your maximum heart rate, or your heart rate
exceeds the target zone values (see target
zone) the red warning light will blink and an
alarm will sound.
 - 60 -