Specifications - Makita DLS713 Bedienungsanleitung

SPECIFICATIONS

Model
Blade diameter
Blade body thickness
Hole (arbor) diameter
Max. Miter angle
Max. Bevel angle
Max. Cutting capacities (H x W) with blade 190 mm in diameter.
Miter angle
0°
45° (left and right)
57° (right)
-1
No load speed (min )
Dimensions (L x W x H)
Net weight
Rated voltage
(Note)
* mark indicates that a wood facing with the following thickness is used.
1: When using a wood facing 20 mm thickness
2: When using a wood facing 15 mm thickness
3: When using a wood facing 10 mm thickness
• Due to our continuing program of research and development, the specifications herein are subject to change without notice.
• Specifications and battery cartridge may differ from country to country.
• Weight, with battery cartridge, according to EPTA-Procedure 01/2003
Symbols
The following show the symbols used for the equipment.
Be sure that you understand their meaning before use.
･
Read instruction manual.
･
To avoid injury from flying debris, keep
holding the saw head down, after
making cuts, until the blade has come
to a complete stop.
･
When performing slide cut, first pull
carriage fully and press down handle, then
push carriage toward the guide fence.
･
Do not place hand or fingers close to
the blade.
･
Always set SUB-FENCE to left position
when performing left bevel cuts. Failure
to do so may cause serious injury to
operator.
･
Cd Only for EU countries
Ni-MH
Do not dispose of electric equipment or
Li-ion
battery pack together with household
waste material!
45° (left)
25 mm x 300 mm
-----
25 mm x 212 mm
-----
-----
-----
END014-6
7
Bevel angle
0°
52 mm x 300 mm
* 60 mm x 265 mm (Note 1)
52 mm x 212 mm
* 60 mm x 185 mm (Note 2)
52 mm x 163 mm
* 60 mm x 145 mm (Note 3)
In observance
Directives, on Waste Electric and
Electronic Equipment and Batteries and
Accumulators and Waste Batteries and
Accumulators and their implementation
in accordance with national laws,
electric equipment and batteries and
battery pack(s) that have reached the
end of their life must be collected
separately
environmentally compatible recycling
facility.
Intended use
The tool is intended for accurate straight and miter
cutting in wood.
Noise
The typical A-weighted noise level determined according
to EN61029:
Sound pressure level (L
Sound power level (L
Uncertainty (K) : 3 dB (A)
Wear ear protection
DLS713
190 mm
1.3 mm - 2.0 mm
20 mm
Left 47°, Right 57°
Left 45°, Right 5°
5° (right)
40 mm x 300 mm
-----
-----
-----
-----
-----
655 mm x 430 mm x 454 mm
12.7 kg
D.C.18 V
of the European
and returned to
ENE076-1
ENG905-1
) : 88 dB (A)
pA
) : 98 dB (A)
WA
2,200
an