Connector
Stranded wire cross section (with ferrule)
Stranded wire cross section (without ferrule)
Stranded wire stripping length
Torque range
Required tool
External insulation required
WARNING
The digital input cables shall have the right length so that they do not apply
a mechanical strain to this equipment. Failure to observe this requirement
creates an electrical shock hazard and may also damage this equipment.
CAUTION
The cables connected to the digital inputs (connector X3) shall each be less
than 3 meters long in order to maintain EMC compliance.
X3
0.2 – 2.5 mm
2
0.2 – 4 mm
2
7 mm
0.4 – 0.5 Nm
torque wrench with
0.6 × 3.5 mm flat-blade
functional
53