Warranty - Protool VCP 260 E-H Bedienungsanleitung

Service
Once a year as a minimum a manufacturer of an
authorized person should inspect the machine
for dust, i.e. damage on the filter, machine
tightness, and function of the control elements
should be checked.
Guarantee and post-guarantee service and
repair may be performed by service shops as
listed.
Recycling
After their service life is ended, submit the
electric tool, its accessories and packages to a
disposal premise to allow reusing of the raw
materials.
To allow material-sorted recycling, all plastic
components are marked with relevant symbols.
Storage
Packed electric tools may be stored in dry
unheated storerooms with temperatures not
dropping below - 5°C. Unpacked electric tools
shall be stored only in dry self-contained
storerooms with temperatures not dropping
below + 5°C, where sudden temperature
changes are prevented.
14

Warranty

Our equipment is under warranty for at least
12 months with regard to material or production
faults in accordance with national legislation. In
the EU countries, the warranty period for
exclusively private use is 24 months (an invoice
or delivery note is required as proof of purchase).
Damage resulting from, in particular, normal
wear and tear, overloading, improper handling,
or caused by the user or other damage caused
by not following the operating instructions, or any
fault acknowledged at the time of purchase, is
not covered by the warranty.
Complaints will only be acknowledged if the
equipment has not been dismantled before being
sent back to the suppliers or to an authorised
customer support workshop. Store the operating
instructions, safety notes, spare parts list and
proof of purchase in a safe place. In addition, the
manufacturer's current warranty conditions apply.
Note
We reserve the right to make changes to the
technical data contained in this information as a
result of ongoing research and development
work.
Product conformity
declaration
We declare with our full responsibility that this
product complies with the requirements of the
following standards and regulations:
EN 60 335-1, EN 60 335-2-69, EN 55 014-1,
EN 55 014-2, EN 61 000-3-2, EN 61 000-3-3
according to the provisions of the directives
73/23/EEC, 89/336/EEC.
Manfred Kirchner