Initial Use; Setting The Time - Silvercrest IAN 285662 Bedienings- En Veiligheidsinstructies

VHF cable aerial
Unwind the cable aerial

Initial use

Setting the time

Note: Make sure to set the time quickly as entering the settings is
interrupted after approx. 5 seconds if a button has not been pressed. All
settings made so far will be automatically saved.
Press the TIME / SET button
clock ( ) flashes on the display
To switch between the 24 hour clock (
( ), press the VOL + / MIN -button
To apply the setting, press the TIME / SET button
Press the TIME / SET button
display .
1
To set the hour, press or hold the VOL - / HR -button
To set the minutes, press or hold the VOL + / MIN -button
To apply the set time, press the TIME / SET button
Note: If the 12 hour clock has been set, from 12:00 midday a dot
(PM) appears in the upper right corner of the display
Note: If the product is disconnected from the power supply and no
batteries have been inserted the time, alarm clock, station memory
will be erased.
38 GB/IE
completely for the VHF reception.
3
for approx. 2 seconds. The 24 hour
9
.
1
) and the 12 hour clock
or VOL - / HR -button
6
. The time flashes now on the
9
.
5
again.
9
.
5
.
6
.
9
1