How To Use; Temperature Setting; Programme Buttons; Temperature Limitation - clage CFX-U Gebrauchsanleitung

CFX-U FUNKTRONIC MPS ®

3. How to use

EN
Set temperature
1
–1 °C
Convenience zone 35,0..42,0 °C
1
– 0,5 °C
Select preset temperature
A1
B1
Store temperature
1
Set required
temperature
(e.g. 43 °C)
4
Display of new value (e.g. 43 °C)
calding protection on
S
1
Scalding protection off
1
+
Press
≥ 3 sek
The water heater is operated with the wireless remote control.
As soon as you open the hot water tap, the instantaneous water heater switches
on auto matically. When the tap is closed, the appliance automatically switches
off.

Temperature setting

You can set the required temperature gradually to a lower or higher value with the
arrow keys
The temperature changes by 1 °C, in the convenience zone between 35 °C and 42 °C by
+1 °C
0.5 °C, if key is pressed shortly one time. Pressing a key for a longer time changes the
temperature continuously.
Note: If temperature is set below 20 °C with arrow key
and the appliance switches off the heating function.
+0,5 °C
Note: If the water heater supplies a shower and is connected to a remote control
system, the maximum temperature was reduced during initial operation. This
limitation cannot be exceeded.

Programme buttons

A2
The two programme buttons allow to quickly select the preset temperature. When
pressing a programme key, the preset temperature is selected and displayed. The fac-
tory setting for programme
B2
your own settings for the programme keys:
• Prolonged pressing of the programme key stores the previously selected tem-
perature. The display changes from "P1" or "P2" to the newly stored temperature
value. This newly set temperature is now available to you each time you press the
2
corresponding program key.
Press
≥ 3 sec
3

Temperature limitation

This instantaneous water heater is equipped with an optional temperature limiting
2
function. This scalding protection is deactivated in the factory setting.
+
• Switch on: Select the limit tempe ra ture, then press
least 3 sec. The dis play briefly confirms the activation by "HI".
Press
≥ 3 sec
• Switch off: press program key
play briefly confirms the deactivation by "--".
Note: By activation of the temperature limit also the programme keys are affect-
ed. Therefore, the fixed values of the programme keys must be checked after
2
changing the temperature limitation.
Confirmation
of deactivation
and .
is 35 °C and for programme
and simultaneously for at least 3 sec. The dis-
14
the display shows "--"
it is 48 °C. You can assign
and simul taneously for at