7.6 Programming/Change of "Aux Out" (9)
The factory setting is no password for "Aux Out" relay contacts (9).
Proceed as follows:
Input example:
MMMM MMMM *40 code #
7.6.1 Setting Closing Duration for "Aux Out" Relay Contacts (9)
You can define the closing duration of the "Aux Out" (9) relay contacts.
The factory setting for the closing duration is 00 (=activation until the AUX
password is entered.
Proceed as follows:
Input example:
MMMM MMMM *58 TTT #
7.6.2 Setting Reaction Mode for "Aux Out" Relay Contacts (9)
The factory setting is for the "Aux Out" relay contacts (9) to be activated by the password for the
"Aux Out" relay contacts (9).
You can however activate the relay contacts in different ways. For this purpose, this code lock
offers you convenient options to specify an activation mode.
To set the required activation mode, please enter the following combination:
MMMM MMMM * 57 C #
C in this case stands for the desired mode type.
28
Explanation
code = new password for activating "Aux Out" (9);
(4-8 characters)
Explanation
TTT = 001-999 seconds
TTT = 000 Activation until AUX password is-
entered