INVENTOR V5MCI32-18WiFiR/U5MRS32-18 Benutzerhandbuch Seite 10

NOTE: Some models include an auto-lifting
panel function, which allows the grill to move
vertically and simplifies the filter cleaning process.
4. Remove the air filter.
5. Clean the air filter by vacuuming the surface
or washing it in warm water with mild
detergent.
A. If using a vacuum cleaner, the inlet side
should face the vacuum.
B. If using water, the inlet side should face
down and away from the water stream.
ƒ Page 10 „
Fig. 4.2
Fig. 4.3
Fig. 4.4
6. Rinse the filter with clean water and allow it
to air-dry. DO NOT let the filter dry in direct
sunlight.
7. Reinstall the filter.
8. Reinstall the front grille and reconnect the
display panel cable to the control box on the
main body.
Repairing Refrigerant Leaks
WARNING
If the refrigerant leaks, turn off the air
•
conditioner and any combustible heating
devices, ventilate the room and call your
dealer immediately. Refrigerant is both toxic
and flammable. DO NOT use the air
conditioner until the leak is repaired.
When the air conditioner is installed in a
•
small room, measures must be taken to
prevent the refrigerant concentration from
exceeding the safety limit in the event of
refrigerant leakage. Concentrated
refrigerant causes a severe health and safety
threat.
Refrigerant Leak Detection System
(some models)
In the event of a refrigerant leak, the LCD
•
screen will display "EC" and the LED indicator
light will flash.
Preparation For Periods Of Non-Use
Maintenance after Extended Non-Use
1. Remove any obstacles blocking the vents of
both the indoor and outdoor units.
2. Clean the air filter and the front grille of the
indoor unit. Reinstall the clean, dry air filter in
its original position.
3. Turn on the main power switch at least 12
hours prior to operating the unit.
Storing the Unit While Not In Use
1. Run the appliance on FAN mode for 12 hours
in a warm room to dry it and prevent mold.
2. Turn off the appliance and unplug it.
3. Clean the air filter according to the instructions
in the previous section. Reinstall the clean, dry
filter before storing.
4. Remove the batteries from the remote control.