Warranty Information; Installation - Siko IG06 Benutzerinformation

User Information
IG06, IG16, IG07, IG17
Incremental encoder
IG06
IG07
Hollow shaft encoder
ENGLISH

1. Warranty information

• In order to carry out installation correctly, we
strongly recommend this document is read very
carefully. This will ensure your own safety and the
operating reliability of the device.
• Your device has been quality controlled, tested and
is ready for use. Please observe all warnings and
information which are marked either directly on
the device or specified in this document.
• Warranty can only be claimed for components sup-
plied by SIKO GmbH. If the system is used together
with other products, there is no warranty for the
complete system.
• Repairs should be carried out only at our works.
If any information is missing or unclear, please
contact the SIKO sales staff.
2. Identification
Please check the particular type of unit and type
number from the identification plate. Type number
and the corresponding version are indicated in the
delivery documentation.
e. g. IG07-0023
version number
type of unit

3. Installation

For mounting, the degree of protection specified
must be observed. If necessary, protect the unit
IG06, IG16, IG07, IG17
IG16
IG17
Solid shaft encoder
Datum 25.03.2013
against environmental influences such as sprayed
water, dust, knocks, extreme temperatures.
Important information! Radial shaft sealings are
subject to wear! Protection class therefore depends
on life and condition of sealings.
Mounting instructions
Please handle the encoder carefully as it is a high-
precision device.
Especially do not:
• disassemble or open the encoder (unless stipulated
in this brochure).
• link encoder's shaft with rigid couplings as this
would expose the encoder's shaft bearing to high
forces. For solid shaft encoders we recommend
the use of SIKO flexible shaft coupling type AK18.
• knock on casing or shaft; the encoder's inner com-
ponents (e. g. the coded disk) could be damaged.
• machine (bore, mill ...) flange or shaft. This could
lead to severe damage inside the encoder.
• exceed the values for the maximum axial and
radial shaft load.
• mount the encoder incorrectly.
Otherwise manufacturer's warranty will be invalida-
ted!
NEVER ...
Fig. 1: Mounting instructions
Mounting of the encoder
• Fixation either by screws or via torque pin and shaft
clamping. Ensure that the encoder is mounted
without strain and use torque pin.
• Forces must not be transmitted via the housing,
but only via the shaft.
• Do not exceed the values for the maximum axial
and radial shaft load.
Art.Nr. 79650 Änd. Stand 106/13 7