Nice MORX Gebrauchsanleitungen Seite 13

To activate output-2
•
1) - Hold the card up to the reader: after the beep, move the card away from the
reader; then...
2) - (within 2 seconds) swipe the card over the reader again: it beeps and immedi-
ately activates output-2.
SECTION - 7.A
EASY PROGRAMMING PROCEDURE
+ card reader)
l EASY programming allows you to program up to two different cards: one for out-
put-1 and one for output-2. You can also program a single card for both outputs. •
You can also cancel the memory using the key on the decoder. • EASY program-
ming offers no other functions.
l The decoder's outputs (1 and 2) operate as momentaries; each output is activat-
ed when the card is held up to the reader and deactivates as soon as the card is
held up to the reader a second time.
7.A.1 Easy
To program a card for output-1 only
CAUTION! – This procedure is an alternative to that given in par. 7.A.3.
01. Press the decoder key: – the decoder will start beeping regularly. – The beeps will
continue for 30 seconds; within this time...
02. ...hold the card up to the reader 1 time. Note – You can program more cards
after the first one, by repeating step 02 for each of them within 10 seconds after
the previous card was held up to the reader.
03. To terminate the procedure, wait for the 10 seconds period after the last card to
time out.
If you wish, you can save more cards to the reader at any later time by repeating the
procedure.
7.A.2
To program a card for output-2 only
CAUTION! – This procedure is an alternative to that given in par. 7.A.3.
01. Press the decoder key: – the decoder will start beeping regularly. – The beeps will
continue for 30 seconds; within this time...
02. ...hold the card up to the reader 2 times. Note – You can program more cards
after the first one, by repeating step 02 for each of them within 10 seconds after
the previous card was held up to the reader.
(for MORX 03. To terminate the procedure, wait for the 10 seconds period after the last card to
time out.
If you wish, you can save more cards to the reader at any later time by repeating the
procedure.
7.A.3
To program a card for both output-1 and output-2
CAUTION! – This procedure is an alternative to that given in par. 7.A.1 and 7.A.2.
01. Press the decoder key: – the decoder will start beeping regularly. – The beeps will
continue for 30 seconds; within this time...
02. ...hold the card up to the reader 3 times. Note – You can program more cards
after the first one, by repeating step 02 for each of them within 10 seconds after
the previous card was held up to the reader.
03. To terminate the procedure, wait for the 10 seconds period after the last card to
time out.
If you wish, you can save more cards to the reader at any later time by repeating the
procedure.
7.A.4
To program a new card with a previously
programmed card
To run this procedure, you need an old (previously programmed) card, from which the
new card will take its settings (output-1, output-2, or both (1 and 2).
01. Hold the new card up to the reader for at least 5 seconds. Move the card away
from the reader.
02. Now swipe the old (previously programmed) card over the reader 3 times.
03. Hold the new card up to the reader 1 more time.
To save another card, repeat the procedure from the beginning.
Easy
Easy
Easy
English – 12