Carrier XPOWER 42PQV S Serie Gebrauchsanweisung Seite 11

42PQV...S
Use of the remote control
DAILY timer (Everyday - button J)
Push the button when the ON or OFF timer is active. The icon
will appear on display. In this way the ON and OFF timer
memorization will be repeated every day. To disactivate the daily
function, press again the button
Combination of ON, OFF and DAILY timer
procedure
If you want operation to start at 5.30 P.M. and stop at 10.30 P.M.,
proceed as follows:
1.
Select ON timer at 5:30 P.M.
2.
Select OFF timer at 10:30 P.M.
3.
Select the desired operating mode (button
PM
If you want to stop operation at 10:30 P.M. and start again at
7:30 A.M. with the same operating mode, proceed as follows:
1.
Select OFF timer at 10:30 P.M. during operation
2.
Select ON timer at 7:30 A.M.
PM
If you want Everyday operation to start at 5.30 P.M. and stop at
10.30 P.M., proceed as follows:
1.
Select ON timer at 5:30 P.M.
2.
Select OFF timer at 10:30 P.M.
3.
Press the Everyday button (daily button
PM
PM
Cancellation of ON, OFF and DAILY timer
procedure
1.
If you want to cancel On or OFF timer
setting, press the following buttons in
sequence:
• button
A 1
B 2
• button
To deactivate the Everyday function, press
button
The Everyday function will remain operative
PM
until one of the two timers (ON or
OFF) is active.
GB - 10
.
).
PM
AM
).
PM
or ;
.
.
Sleep timer procedure "night"
Press this button to set the SLEEP timer with remote control on.
The icon will appear on the display.
This procedure permits setting the remaining unit operating time.
1.
"1:hr" will be displayed together with the
icon.
2.
Press button
The display will show the following
A 1
settings in sequence: 1 hr, 2 hr, 3 hr, 4
B
2
hr, 5 hr, 6 hr, 7 hr, 8hr and 9 hr.
3.
Once the remaining operating hours
have been selected with either button
or
4.
When the SLEEP timer is set, the unit
will control the set temperature to avoid
overcooling or overheating during
operation. The set temperature will
change as follows:
°C
+0.5°C
SET
30
SET TIME
(Cooling only or dehumidification)
°C
-1°C
SET
30
SET TIME
Ionizer function button
1.
Press Ionizer button
Ionizer function during unit ON.
2.
Press Ionizer button
Ionizer function.
Address selector
If you have two indoor units in the same room, you can link one
remote control to one indoor unit, and the other remote control to
the other indoor unit, or you can control both indoor units with a
single remote control.
For configuration, refer to the installation manual.
(button M)
(temperature increase).
, again press button to confirm.
+0.5°C
+0.5°C
+0.5°C
TIME
70 110 150
-1°C
-1°C
90 150
TIME
(Heating)
(button N)
to activate
again to stop