Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
42PQV...S
Use of the remote control
Selecting the fan speed
-
(button E)
The fan speed can be selected by pressing button
Indicated symbol
Low speed
(for night operation)
Medium speed
High speed
(at start-up, to reach temperature)
Automatic (fan speed will automatically switch to the value
required for optimum comfort).
ON timer procedure
1 .
ON TIMER button
Press this button, even if the remote
control is OFF. The relevant icon and time
figure will start to flash.
If 10 seconds have elapsed and no button
is pressed, the remote control turns OFF
(if it was already OFF when button
pressed) or timer function automatically
deactivates.
2.
HOUR/MINUTE buttons
(buttons
If the unit is ON, the only possible
selection is the start-up time.
The unit will operate with the selections
shown on the display.
3.
HOUR/MINUTE buttons
(buttons
If the unit is OFF: to select the start-up
time, use the temperature control buttons
(buttons
First select the hours and, after have
confirmed these by pressing button
select the minutes using either button
or
To definitively set the time, press button
again.
4.
Operating mode
Choose the unit operating mode.
The icons will flash.
To select the mode, use the button
Once the mode has been decided, press
button
will stop flashing.
5.
Desired temperature
To select the desired temperature, (the
value is flashing, use either button
Push button
Numbers will stop flashing.
6.
Fan speed
Choose the fan speed, using button
When the selection has been completed,
press button
The icon will stop flashing.
.
(button I)
and
)
and
)
and
).
.
. The icon of the selected mode
, to confirm the selection.
for confirmation.
About the ON timer
OFF timer procedure
was
Personalisation
,
If you want memorize a personalised operating mode, recallable
at any time, proceed as follows:
1. Press and hold the personalisation button for 5 continuous
seconds.
On the display, the personalisation icon
2. Press button
.
3. Press either button
4. Using button
5. Using button
6. When all options have been entered, press button
or
.
memorise them.
At this point, all selected and memorised functions can be
activated through button
Once the personalised mode has been entered, press one of the
buttons
,
,
.
If you want to change one or more memorised parametres, begin
again from point 1.
7.
Louvre positioning
Now this icon is flashing.
Use button
, to select desired position.
Press button
for confirmation.
Now all icons are fixed on display.
If you want to cancel selections up to here
inserted, push button
cancel all options once timer has been set,
push button
and then
• When the ON Timer function is operating,
the unit senses the room air temperature
1 hour before the start-up time.
•
The unit start can be brought forward
based on the programmed start time, by 0
to 40 minutes, depending on the tempera-
ture difference between the room and the
selected temperature.
1.
OFF TIMER button
Press button
.
The OFF timer icon and numbers for time
selection are flashing.
This function can be set even if the remote
control is OFF.
2.
HOUR/MINUTE selection buttons
(buttons
and
)
To set the clock time, press either button
To move from hour to minute, press button
Press button
again to confirm.
(buttons F)
will start flashing.
, to select the operating mode.
or
to select the desired temperature.
select the fan speed.
select the louver operation.
, whatever the unit operating mode.
,
to exit.
E N G L I S H
; if you want to
.
(button L)
or
.
.
to
GB - 9
Quicklinks ausblenden:
Werbung
Kapitel
Inhaltsverzeichnis
