Installation; Placing; Mains Power Supply - ESAB Caddy Mig C200i Betriebsanweisung

GB
Enclosure class
Application classification
Duty cycle
The duty cycle refers to the time as a percentage of a ten--minute period that you can weld at a cer-
tain load without overloading.
Heating tests have been carried out at ambient temperature and the duty cycle at 40
determined by simulation.
Enclosure class
The IP code indicates the enclosure class, i. e. the degree of protection against penetration by solid
objects or water. Equipment marked IP23C is designed for indoor and outdoor use.
Application class
The symbol indicates that the power source is designed for use in areas with increased
electrical hazard.
5

INSTALLATION

The installation must be executed by a professional.
CAUTION!
This product is intended for industrial use. In a domestic environment this product may
cause radio interference. It is the user's responsibility to take adequate precautions.
5.1

Placing

Position the welding power source such a way that its cooling air inlets and outlets
are not obstructed.
5.2

Mains power supply

Check that the unit is connected to the correct mains power supply voltage, and that
it is protected by the correct fuse size. A protective earth connection must be made,
in accordance with regulations.
Caddy R R R R Mig C200i
Voltage V
Current A
at 100% duty cycle
C200ie
IP 23C
Rating plate with supply connection data
1∼ 50/60 Hz
230±15%
10
- - 60 - -
o
C has been