Selecting The Camera To Be Controlled - Canon VC-C50i Gebrauchsanleitung

ID Mode

Selecting the Camera to be Controlled

<Example> As shown in the figure below, of 4 cameras (ID1 to ID3) only the cameras with
● Check the LEDs on all the adjacent connected cameras to ensure that all the
NOTE
● The cameras (ID: 0) that have not been assigned on ID number are switched
● Even if the cameras are switched off, when you press the i button the
BRIGHT ZOOM
T
W
HOME
SET/OK CANCEL
1 2 3
AF
4 5 6
MF
∞
7 8 9
0
ON SCREEN Fn ID MENU
36
ID number 2 (2 cameras) are selected for ID mode operation. In normal
operation, the camera LEDs turn green.
ID1
Green
cameras are receiving the signals from the wireless controller.
on in step 2.
LEDs on all the cameras blink orange and you can begin ID mode operation.
However, when a number button was pressed in step 2, the cameras with ID
numbers that do not match are switched off.
1. Press the i button.
The LEDs on all the adjacent connected cameras blink orange
(at 0.5-second intervals).
ID1
Blinking orange
To cancel ID mode operation, press the c or i button. The
LEDs on all the cameras then turn green.
2. Press a number button (in this case 2).
The cameras with ID2 are selected and the LEDs on only those
cameras turn green. The LEDs on the other cameras turn orange
(not blinking).
ID1
Orange
This completes the selection procedure. When you use the wireless
controller, only the selected cameras will respond. When you press
a button on the wireless controller, the LEDs on the selected
cameras blink green (at 0.1-second intervals) and the LEDs on the
other cameras blink orange (at 0.1-second intervals).
ID2 ID2
Green Green
ID2 ID2
Blinking orange Blinking orange
ID2 ID2
Green Green
ID3
Green
ID3
Blinking orange
ID3
Orange