Care And Maintenance - Cocraft LXC MTG18 Original Bedienungsanleitung

Take the following points into consideration when using
the trimmer
• Make sure that there are no hidden obstacles (metal poles/wire fences) in the area
to be trimmed.
• Max branch diam: 8 mm.
• Hold the trimmer firmly; maintain a steady stance and do not lean out too far.
Be extra careful when using a ladder.
• Move the trimmer along in a slow and steady motion.
• The double-sided blade enables trimming in both directions or in a pendulum
action from side to side.
• For even trimming on the sides it is better to cut in the direction of growth, from
the bottom up.
• If you trim from the top down, the thinner twigs will bend out and there is a risk of
holes or thin patches appearing in your hedge.
• In order to ensure a straight top edge, you can stretch a length of string over
the hedge as a guide.
Switching on
1. Remove the sheath from the hedge trimmer cutter
bar/grass shears.
2. Slide the battery into the grooves of the battery
connection on the bottom of the handle (4) making
sure that it clicks securely into place.
3. Slide the trigger safety switch to the side and press
the power trigger. The grass shears/hedge trimmer
should now start.
4. The grass shears/hedge trimmer will stop
automatically when the power trigger is released.

Care and maintenance

Warning:
• Always remove the battery before performing any service or maintenance.
• Wear protective gloves when handling or cleaning the blades.
• Regularly check that the on/off switch and safety lock are undamaged and
work correctly.
• Check regularly and lubricate
the blades with appropriate lubricant
and make sure that the screws in
the cutter bar are tight.
9