Troubleshooting Guide - Cocraft LXC MTG18 Original Bedienungsanleitung

• Lubricate the blades with an appropriate lubricant if the tool is not to be used for
a long time.
• Clean the exterior of the motor housing using a damp cloth. Use only mild cleaning
agents, never solvents or corrosive chemicals.
• Remove all dirt, especially from around the motor ventilation slits.
• Whenever the tool is not to be used for a long time, it should be stored in a dry,
dust-free environment, out of children's reach.
• Do not store the battery in temperatures below zero.
• Always keep the sheath on the grass shears and hedge trimmer cutter bar when
the tool is not in use.

Troubleshooting guide

The shrub/grass shears
won't start.
The shrub/grass shears
are sluggish and/or cut
out.
Poor battery
operating time.
The battery does not
charge.
Responsible disposal
This symbol indicates that this product should not be disposed of with
general household waste. This applies throughout the entire EU. In order
to prevent any harm to the environment or health hazards caused by
incorrect waste disposal, the product must be handed in for recycling
so that the material can be disposed of in a responsible manner. When
recycling the product, take it to your local collection facility or contact
the place of purchase. They will ensure that the product is disposed of in
an environmentally sound manner.
Discharged or incorrectly inserted battery.
Charge the battery and ensure that it is properly fitted
to the battery connection.
• The blades are blunt or damaged.
Check and replace if necessary.
• Too much force applied. Decrease the applied force.
• The battery might be overheated. Read the Overload
protection and other safety features section.
• The battery is not fully charged. A few charging
cycles where the battery is charged 100% might be
needed before it reaches full capacity.
• The battery needs replacing.
• The battery is not correctly inserted into the charger.
• The battery or charger contacts are dirty.
Disconnect the charger from the power supply
and clean the contacts.
• The mains lead is not securely plugged into the wall socket.
• Check that the wall socket is energised.
• The charger or mains lead is damaged.
• The battery needs replacing.
10