Stand-Alone Mode - EuroLite LED STL-9 Bedienungsanleitung

master device via a balanced microphone lead. Set the DMX start address 001 on every slave device.
Connect the DMX OUT-jack with the DMX IN-plug of the next device.
Connection with the mains
Connect the device to the mains with the enclosed power supply cable.
The occupation of the connection-cables is as follows:
Cable Pin
Brown Live
Blue Neutral
Yellow/Green Earth
The earth has to be connected!
If the device will be directly connected with the local power supply network, a disconnection switch with a
minimum opening of 3 mm at every pole has to be included in the permanent electrical installation.
The device must only be connected with an electric installation carried out in compliance with the IEC-
standards. The electric installation must be equipped with a Residual Current Device (RCD) with a maximum
fault current of 30 mA.
Lighting effects must not be connected to dimming-packs.
Please note: A maximum of 8 EUROLITE LED STL-9 may be linked together. After every 8 devices, the
fixtures must have a renewed connection with the power mains.
OPERATION
After you connected the spot to the mains, the EUROLITE LED STL-9 starts running.
The LED display lights up and you can choose the desired mode via the buttons MODE, ENTER, UP,
DOWN.
The device has two operating modes. It can be operated in Stand Alone or in DMX-controlled mode.

Stand-alone mode

In the stand-alone mode, the LED STL-9 can be used without controller.
Disconnect the LED STL-9 from the controller.
Control Board
Browse through the main menu by pressing MODE. You can browse through the selection menu and confirm
your choice by pressing ENTER. You can change the selection by pressing UP or DOWN. The functions
provided are described in the following sections.
Dimming:
Display:
C:00 F00
Press button Mode, adjust the brightness (C00-99) or Flash speed (F00-99).
Slave Mode:
Display:
International
L
N
DIMMER
SLAVE
M O D E
21/23 00063567.DOC, Version 1.2