Specifications - Makita HM1801 Bedienungsanleitung

ENGLISH (Original instructions)
1-1. Switch lever
2-1. Indicator lamp
3-1. Bit with collar
3-2. Bit without collar
4-1. Bit
4-2. Tool retainer
4-3. Tool holder
4-4. When the bit is inserted
4-5. When the bit is retained

SPECIFICATIONS

Blows per minute
• Due to our continuing programme of research and development, the specifications herein are subject to change without notice.
• Specifications may differ from country to country.
• Weight according to EPTA-Procedure 01/2003
Intended use
The tool is intended for heavy chiselling and demolition
work as well as for driving and compacting with
appropriate accessories.
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and
can only be operated on single-phase AC supply. They
are double-insulated and can, therefore, also be used
from sockets without earth wire.
For public low-voltage distribution systems of
between 220 V and 250 V.
Switching operations of electric apparatus cause voltage
fluctuations. The operation of this device under
unfavorable mains conditions can have adverse effects
to the operation of other equipment. With a mains
impedance equal or less than 0.31 Ohms it can be
presumed that there will be no negative effects. The
mains socket used for this device must be protected with
a fuse or protective circuit breaker having slow tripping
characteristics.
Explanation of general view
5-1. Notched portion
5-2. Tool retainer shaft
5-3. Barrel
5-4. When the bit is inserted
5-5. When the bit is retained
6-1. Commutator
6-2. Insulating tip
6-3. Carbon brush
7-1. Hex wrench 5
Model
Overall length
Net weight
Safety class
HM1801
1,100
824 mm
29.7 kg
ENE046-1
Noise
The typical A-weighted noise level determined according
to EN60745:
Model HM1801
ENF002-2
Sound pressure level (L
Sound power level (L
Uncertainty (K) : 2.30 dB(A)
Model HM1810
ENF100-1
Sound pressure level (L
Sound power level (L
Uncertainty (K) : 2.52 dB(A)
Vibration
The vibration
determined according to EN60745:
Model HM1801
Work mode : chiseling
Vibration emission (a
Uncertainty (K) : 1.5 m/s
Model HM1810
Work mode : chiseling
Vibration emission (a
Uncertainty (K) : 1.5 m/s
3
7-2. Motor housing cover
8-1. Cap rubber
9-1. Brush holder cap
9-2. Screwdriver
10-1. Cap
10-2. Lock nut wrench 20
11-1. Cap
11-2. Hex wrench 8
12-1. Hammer grease
HM1810
1,100
824 mm
32.3 kg
/II
) : 84 dB(A)
pA
) : 104 dB(A)
WA
) : 84 dB(A)
pA
) : 104 dB(A)
WA
Wear ear protection
total value (tri-axial
) : 14.0 m/s
h,CHeq
2
) : 9.0 m/s
h,CHeq
2
ENG905-1
ENG900-1
vector sum)
2
2