Inserting/Replacing Activated Coal Filters; Operation) - Privileg SY-3502D-E5-C59-L52-600 Gebrauchsanleitung

Page EN-18 Care and maintenance
4. Re-insert the grease filters once they
are completely dry. To do this, insert the
grease filters in the recess below.
5. Push the lock back, press the grease
filters upwards and release the lock. The
grease filters will snap into place.
6. Switch the power back on.
Inserting/replacing activated
coal filters (only in circulation
air operation)
The activated coal filters remove odours.
They have to be replaced as soon as the
cooking odours can no longer be adequately
filtered.
If used frequently, you should change the
filters regularly. Check them at least every 6
months.
For the source of supply, please see chapter
„Our Service Centre" on page EN-21.
1. Unplug the mains plug or switch off the
corresponding circuit.
2. Push down the lock on the grease fil-
ters (12) and carefully pull the grease
filters downwards to remove them.
3. Only when replacing:
Unscrew the old activated coal filter (13)
from the motor and remove the activated
charcoal filter.
4. Put on the new activated charcoal filters
to the right and left of the motor and tight-
en them.
5. Re-insert the grease filters. To do this,
push the lock of the grease filters back,
press the grease filters upwards and re-
lease the lock. The grease filters will snap
into place.
6. Switch the power back on.
7. Dispose of the used activated charcoal
filters with household waste.
(12) (12)
(13)