Fault Diagnostics - Siemens SCD 19101 D Betriebsanleitung

09.08
7

Fault diagnostics

Fault
No picture appears on the
display,
operation LED off
No picture appears on the
display, operation LED
flashes slowly
No picture appears on the
display, operation LED
flashes rapidly
Fuzzy picture,
interference in vertical
lines
Other faults
Hochauflösendes 19" Color Flat Panel Display SCD 19101 D/DT
A5E00316182-002
Cause
Power cable not inserted
or incorrectly inserted.
No voltage.
Power supply unit faulty
Monitor not switched on
No video signal
Scanning frequency or
phase incorrectly set
Loose plugs / connecting
cable faulty
Faults in video signal
(contaminated
environment)
Problem with PC/graphics
card
instruction manual
Remedy
Insert power cable
Switch on power supply
Inform servicing
department
Switch on the monitor
using the "down, on/off"
key
Check video cable,
switch on PC
Adjust frequency and
phase
Plug cables in properly
and secure them /
replace connecting
cable
OSD: Select Options 1,
press noise
suppression "ON", and
test
If the fault is not
eliminated: Set OSD
settings to "OFF" again.
The problem is to be
found in the quality of
the video data/video
transmission. Inform
servicing department
for support if
necessary.
Replace components
45